|Please call owner Greg at 508-328-7848. Boat is in Portsmouth, Rhode Island.
North Sea Cutter hull number 6 was purchased 3 years ago to cruise the intercostal from Newport RI to Florida. We searched for 3 years to find a boat that would be suitable for this trip in comfort with many amenities and in a safe manner. NSC is one of the only boats have only two steps to go from the main deck to fly bridge. The boat has two heads, with showers and bath tub and three separate sleeping areas, 3 zones of heat and air. We have had 3 couples stay comfortably on the boat for more than a week. This fast Trawler style boat is both a fast and efficient cruiser at 15 Knots burns with the twin Yanmar engines together about 15-18 gph. Onan 8MD generator with only 100 hours.
We are willing to consider a trade of another smaller type fishing boat!!
REDUCED TO SELL FROM $229,000.
I am the second owner of the boat; I am listing all the major upgrades that have been added to the original boat that separate our boat "KOT'IJ" from any other NSC on the market. Plus I feel that between me and the prior owner we have worked out all of the issues that have been a concern with these NSC boats. All the work has been completed by one of the most Trusted and competent Albin Dealers, Standish Boat Yard in Tiverton, RI. Just for comparison this Hull is a HUNT design, and is similar hull to the hulls for the Sabre 43, and the East Bay 43 that cost over 100K more. We are selling our boat because both family situation, wife's health and we have aging parents and our own business will not allow us to take time away to complete this voyage. Our boat is one of the only a few NSC that has full size Fridge and Freezer in the galley. The custom interior of teak and holy impresses all that come aboard. Just had all the exterior teak professionally re-done with two coat of sealer and 8 coats of Varnish.
Upgrades Include the following: Ray Marine electronics Chart plotter Radar Series E 80, Autopilot, Side power Bow Thruster w - two station with wireless lanyard remote, New 6 @ 8D AGM Batteries, New cushions for cabins and for fly bridge, Custom Captain and first Mate seats, Re-piped all fuel lines to both black iron fuel tanks, new fresh water pumps, Hard Top for Fly bridge has built in white and red lights with 2013 canvas surround with Else glass, all panels able to unzip and snap on to hard top, added separate VHF to lower station. Custom wood cabinetry for V-birth, new foam mattress for V-birth, new cushions throughout with new shades for all windows, re-bedded all port holes.
Standard Specs of the boat.
LOA: 40 ft , 43 ft with bow sprit and swim platform.
Beam: 13 ft.
Minimum Draft: 4 ft.
Dry Weight: 30,000 lbs.
Total Power: 740 HP, Twin Yanmar 370 6LYASTP hours 400. Cruising Speed: 15-20 knots.
Fresh Water Tanks: (200 Gallons).
Fuel Tanks: (400 Gallons).
Holding Tanks: (40 Gallons)
Gray Water Holding tank (25 gallons).
Electrical Circuit: 110V , 50 Amp shore power,
Generator 8KW ONAN,
The galley which is located salon level aft to starboard features a stainless steel sink with a countertop cover and a single lever faucet, a three burner electric cooktop, a Full size refrigerator - freezer, a microwave oven, a trash receptacle and plenty of drawers, cabinets and lockers for storage.. Located in Portsmouth Rhode Island.|
Location: Rhode Island
Contact Number: 508-328-7848
Details & Photos »
|Please call owner Todd at 336-309-1840. Boat is in Lexington, North Carolina.
Single Axle Trailer. Needs an outboard engine.. Located in Lexington North Carolina.|
Location: North Carolina
Contact Number: 336-309-1840
Details & Photos »
|Length: 33.5m - 110ft and a
Beam: 06.04m - 21ft
Draft: 02.02m - 6.38ft.
Displacement of: 165 tons
The cutter is powered by low hour 2012 newly installed twin caterpillar diesel engines affording a maximum speed of 29.5 to 33 knots and a range of 3,300 nautical miles @ 12 knots.
Vessel will operate @ 12 knots on one engine this practice is common.
Vessel can operate QUITE SHIP due to Exhaust mods.
Works Completed in 2012 @ a cost of: $2,700,000.00:
New Engines: Caterpillar 3516 V-16 Twin turbo (3,530 hours of use since rectification of Caterpillar)
New Propeller Shafts
Strut bearings and shaft bearings as needed
New Water Tanks
Vessel completely Rewired
Bigger water pumps for the main engines
Haul out and bottom treated 9 year remaining CARPAC CATODIC SYSTEM
Propellers Re-pitched and conditioned
Hull plates Auto-gaged found in very good condition
New 20 mm Canon mounting brackets
Full exterior painting and boot stripe was done in: latter part of 2014
New mooring lines and fenders
Hydrodynamic Efficiency Improvements completed to this vessel. - (File available). Located in Miami Florida.|
Contact Number: 561-876-8939
Details & Photos »